We have (15) 1999 Wilson Hoppers in Stock. We have 34' X 66",

39' X 66", 40' X 66" ,

41 X 66" Air Ride, 41' X 66" Spring Ride, 41' X 72" and 41' X 78".

Prices Start At: $23,169 For Spring Ride

                     $25,995 For Air Ride

The Wilson Commander is built with Quality and Durability in mind.

These are just a few of the advantages of owning a Wilson Commander Hopper

*Stronger Side Walls due to the one piece seamless skin

*Commanders aerodynamic body lines create less turbulence

*Fast clean unloading

*Independent lower hoppers allows the trailer to twist independently

*Simplified gear boxes for ease of use in discharge hoppers

*Handsome white and natural aluminum exterior gives it a look of quality

IN

STOCK

WILSON COMMANDER

SPECIFICATIONS

Length:            Available in 34 ft. through 43 ft.

Width:             Outside overall: 95 3/4"; 92" inside width.

Height:            Available in four side heights: 66", 72", 78", and 95". Overall heights

                       66"= 122 7/8", 72"= 128 7/8", 78"= 134 7/8, and 95"= 151 7/8. Based on

                       48 1/4" fifth wheel height and 8 5/8" rise on tarp supports.

King Pin:         Standard king pin setting is 22"

Landing Gear:  Vertical 2-Speed square Holland Formula 150 to crank on curb side is

                       standard.  10" x 11 1/2" sand shoes. 50,000 Lb. lift capacity.  Located 92"

                       from king pin on 22" king pin setting.  Retracted landing gear ground clearance

                       is 15" on 48 1/4" fifth wheel height.

Front:              Single wall construction, Sloped front end. Extruded aluminum walkway:

                       7" wide; and ladder assembly.

Sides:              Double-wall construction. Outside skin: 1-Piece, pre-painted white, with full

                       length horizontal corrugations. Inside Skin: 1-Piece aluminum full length.   

                       Drain Ports: one between each set of side of posts in rub rail,  full length

                       of both sides.

Rear End:            Single wall construction. Sloped rear end.

                          Rear Bumper Bar: 2-Piece. Walkway: Extruded

                          aluminum; 7" deep; and ladder assembly.  Stirrup

                          Step: one; attached to the bottom of rear bumper

                          bar.  (Picture shown has optional stainless steel)

Spreader Bars

Tarp Support:     Spreader Bars: 6 permanent aluminum tube type.

                          Tarp Supports: Arched aluminum tube with 85/8"

                          rise.  Ridge Straps: Two nylon; spaced 22" apart

                          at center of trailer.

Hoppers:             Two aluminum hoppers with aluminum corners.  Slopes: 39 1/4" on sides

                           33 1/2" on front and rear.  Stiffeners: 3 extruded aluminum, on the front

                           rear, and 2 on the sides.  Center Divider:  Located inside between hoppers.

Tarp Assemblies: Two aluminum, 27 1/8" wide x 31 1/4" long openings (78" high is 27 1/8"

                           x 43 1/4" standard), and have rack-and-pinion driven openers.

Trap Openers:     Manually open and close with a combination gear reduction and direct

                           drive gear box as standard.

Mud Flaps:          Black ultra rubber anti-spray type with white Wilson logo. Optional:

                           E&R anti-spray flaps

NEXT

HOME

BACK